Printer not powering
Posted: Thu Apr 30, 2020 12:22 am
Hello, I have a Geeetech A10 with a GT2560 V3.1 with TMC2208 for the X Y Z axes, and when I changed the motor (because they were only going in one direction)when rebuilt, my printer doesn't turned on anymore.
Well yes, but 1 second and after the power supply is out, and the printer turns off directly, so I changed the power supply by one sent by the GEEETech support but nothing can be done, I have the same problem, the power supply works 1 second and is out. The fan of the power supply doesn't turn anymore and doesn't send anything (I measured with a multimeter).
Do you have any idea where this could be coming from?
Well yes, but 1 second and after the power supply is out, and the printer turns off directly, so I changed the power supply by one sent by the GEEETech support but nothing can be done, I have the same problem, the power supply works 1 second and is out. The fan of the power supply doesn't turn anymore and doesn't send anything (I measured with a multimeter).
Do you have any idea where this could be coming from?