Page 1 of 1
3d Touch no responce
Posted: Tue Apr 14, 2020 5:43 pm
by Pompelepee
Hi, I installed the 3d Touch, uploaded the firmware, and now I see BLTouch under 'control', but it does not respond to anything. And when I do 'prepare' and bed leveling, he starts and after monitoring the frond left corner he says 'probing failed'. Is the some way that i can load some settings, so he is up to date?
Re: 3d Touch no responce
Posted: Tue Apr 14, 2020 6:29 pm
by William
Hi,you can input the following commends and send them to test it one by one:
M280 P0 S10 ; pushes the pin down
M280 P0 S90 ; pulls the pin up
M280 P0 S120 ; Self test – keeps going until you do pin up/down or release alarm
M280 P0 S160 ; Release alarm
You can adjust the z offset
According to this video in detail:
https://www.youtube.com/watch?v=bny4vqW8JtA