A10M 3D Touch is driving me nuts
Posted: Sat Apr 11, 2020 11:34 pm
So i bought the A10M 2 weeks ago, and first thing i disliked was the leveling of the bed. Did some searching and found the 3D touch sensor. Looked very promising so i ordered one.
Googled and searched on this forum to find information on how to install and so on. The information wasn't that great but i think i did well
Flashed the firmware with the 3D Touch enabled, it's in the A10M menu. Watched that annoying youtube video on how to calibrate the 3D Touch. And even that went well, did an autohome...went well....did auto level bed...went well...2 times.
Now when i autolevel the nozzle moves autohome, does left and middle perfect...then at the right the nozzle dives right into my plate...
Did the whole calibration again, reset the 3D touch...same result. Anyone has an idea on what this could be?
Googled and searched on this forum to find information on how to install and so on. The information wasn't that great but i think i did well
Flashed the firmware with the 3D Touch enabled, it's in the A10M menu. Watched that annoying youtube video on how to calibrate the 3D Touch. And even that went well, did an autohome...went well....did auto level bed...went well...2 times.
Now when i autolevel the nozzle moves autohome, does left and middle perfect...then at the right the nozzle dives right into my plate...
Did the whole calibration again, reset the 3D touch...same result. Anyone has an idea on what this could be?