Geeetech

I do have problems printing parts in cup size. Smaller are fine.
PLA and ABS are similar. I prefer ABS with 105°C bed and 225°C nozzle without fan. Small prints are fine and bigger ones show systematic issues. What can I do? Looks link temporary under extrusion. The meterial still looks too solid but not sticky enough. Flow rate is already 110% in Cura

https://app.box.com/s/90m20o3ujt7qwk47b4avh2287fw6arvz

Just a crazy thought, but I wonder if you might not be over extruding? I had a recent problem where my nozzle got buried in the prior layer, which caused a feed problem. If it were me, I'd try adding a .1mm or .2mm to the level height and try again with the exact same settings. Either the starve will increase or decrease.