A10 5015 Blower Fan

[evant8950]

Hi,

I am trying to replace the cooling fan on my A10 with a 5015 blower, but the connector for the 5015 blower doesn't fit into the connector where the older fan connected into on back of the hotend. How can I connect the fan to the back of the hotend? Is there an adapter to make the connector fit?

I got this fan
https://www.amazon.com/WINSINN-Cooling- ... r=8-1&th=1


Thanks!

[William]

Hi，your pwm port should be 2pin.

[evant8950]

It is 2 pins. Just the connector itself is wider. I guess I need to cut the connector off the new fan and splice it to the connector of the old fan?

Thanks

[Przepka1985]

Most of sockets on geeetech boards it's mini JST, if you buy your one on Amazon ebay etc standard connectors are JST 3mm. I'm usually cut old one and solder to new fan or crimping with new connectors (but it's pain in the....)