Page 1 of 1
e3d v6 installation help!
Posted: Fri Jan 31, 2020 4:14 am
by Graff3
I just got my new extruder in and i am trying to figure out what the a10 extruder wattage is so i know what thermistor to use. Does anyone know the wattage the board uses so i can get this thing up and running?
Re: e3d v6 installation help!
Posted: Fri Jan 31, 2020 4:22 pm
by William
Hi，The motherboard voltage of A10 is 24V, and the thermistor at the hot end is 100kΩ.
Re: e3d v6 installation help!
Posted: Sat Feb 01, 2020 10:36 am
by Graff3
i noticed the stock extruder has 2 thermistors, do i put 2 on with the new one?
Re: e3d v6 installation help!
Posted: Sat Feb 01, 2020 2:59 pm
by William
Hi,if your thermistor already has a thermistor installed, no installation is required.
Re: e3d v6 installation help!
Posted: Sat Feb 01, 2020 11:12 pm
by Graff3
No, I mean the stock head has 2 thermistors coming out of it. Does the e3d require 2 as well? a small and large one like stock?
Re: e3d v6 installation help!
Posted: Sun Feb 02, 2020 10:52 am
by William
Hi,If it is two hot ends, it is two thermistors.
Re: e3d v6 installation help!
Posted: Thu Feb 06, 2020 7:38 am
by Graff3
so it is 1 thermistor and 1 heater cartidge. my issue now is pid auto tuning doesn't do anything and i can't stop temp fluctuations. I have my cooling fan plugged in to my second hotend fan port and running 1 now to see if that helps but i keep getting thermal shutdowns.