Page 1 of 1
Marks on side of benchy
Posted: Fri Jan 03, 2020 6:07 am
by evant8950
Hey everyone
I’m getting close on getting the benchy perfect. Would anyone have any idea on what is causing these marks on the side?
Re: Marks on side of benchy
Posted: Fri Jan 03, 2020 9:49 am
by William
Hi, Are you referring to the trace on your bottom?
You can try to adjust the hot bed,
Do not print too fast.
Re: Marks on side of benchy
Posted: Fri Jan 03, 2020 12:04 pm
by evant8950
The little marks on the side. It was hard to capture on camera. Thanks!
Re: Marks on side of benchy
Posted: Fri Jan 03, 2020 2:20 pm
by William
Hi, You can check the esteps on the screen,
Then see if your machine is loose, you can do it
Fastening treatment.
Re: Marks on side of benchy
Posted: Sat Jan 04, 2020 11:58 pm
by Jarda3d
it is probably un-aligned joints