Geeetech

Hi,

I have a Geeetech A10M. I am using Cura 4.4 printing slicer. I change the values to work with my Geeetech and everything works great except the prime tower. It start off great and then almost half way done the middle of the prime tower stop building right. You can see from the photo outside is great but the middle is not printing right. Please help . I love this slicer.

Did you render gcode? Is tower full or is broken in gcode?

Restart Cura, your OS... repeat slicing.... look at gcode.

Hi, You can view your configuration and re-slice it for printing.

How do i do that?

Hi, You can try to reset it and slice it.