Geeetech

good, I'm back here from my geeetech a10 which is not printing well. I really would like someone to help me. I will try to leave attached photos

https://photos.app.goo.gl/LJP1hJLDjfW4rqJ17

https://photos.app.goo.gl/V34WcbRRNLgwJwJf7

https://photos.app.goo.gl/yrRNKmzyTnegns8u6

https://photos.app.goo.gl/pBg5wJCxJJUy5EaE7

I don't know what to do anymore.

Hi, You can check if your printing temperature is too high,
Can be appropriately reduced by 5-10;

Printing speed reference range: 30-60mm / s;

If a 0.4 nozzle is used, the layer height is recommended to be 80% of the nozzle;

Printing in a well-ventilated area is recommended.

I hope this can help you.

thank you very much for the feedback, already slice the image and tomorrow I will continue with the tests and then post here the result.
Thank you so much for your help

okay,wait your feedback.