Re: Starting a print mid print
Posted: Thu Dec 12, 2019 9:40 am
Hi, Whether your extruder motor can run normally.
Regarding whether the nozzle is clogged, you can try to heat the nozzle temperature to 200 ° and then push the consumables.
See if the material can be discharged normally.
If your model is mixed color, you can check what your ratio is.
Regarding whether the nozzle is clogged, you can try to heat the nozzle temperature to 200 ° and then push the consumables.
See if the material can be discharged normally.
If your model is mixed color, you can check what your ratio is.