Cleaning the Super plate

[Dave Preston]

I am surprised there are no instructions on how to clean the plate. I have only done 5 prints and the last one, the 20 mm xyz calibration cube, came unstuck and moved, so I printed at a different location. Is this supposed to happen, and if so what are the cleaning instructions?
I have read that hairspray and kapton tape are options but Geeetech should provide some information on care of the printer?

[Dave Preston]

Update - After trying to print the xyz cube in a different location it still came off the bed very near the end of the print

[William]

Hi，When you print, you need to heat the temperature of the hot bed to the printing temperature that your printing supplies need.
Level the printer. If cleaning, try isopropyl alcohol.