Geeetech

Dear sir,
Hope that you are well,

I just tried to calibrate my extruders , on my geeetech A10M printer using S3D, and found out that both are slightly not calibrated.

Unfortunately, it seems that i was able to configure the W92=E only once, and not to have adedicated figure for each extruder.

Are you able to send detail information on how to calibrate both extruders? Which each one might have different W92 values.

Appreciate any help.

Hi，You can try to see the step value on the LCD screen,
For example, esteps,
if it is 340, you need to change it to 430 and save it.