Geeetech

Hi there,
I am new to Geeetech printers. Up to now, I only used my Ender 3 (and SparkMaker). I love using Klipper on my Ender 3 and want to use it now with my new A10T. But... pins for the extruders? Sensor type? Sensor pin? Anyone experience with that?

Ok,
I see the .cfg for the A10M with:
step_pin: ar46
dir_pin: ar44
enable_pin: !ar12
for extruder 0

step_pin: ar49
dir_pin: ar47
enable_pin: !ar48
for extruder 1

BUT
I can´t find any documentation about the pins for extruder 2.
Help please!

step 43
Dir 45
EN 41

A guy in the Geeetech 3D Printer User Club just answered.
Bruce Greenleaf

He measured and installed Marlin 2.0.

I am afraid, there is no working bootloader on my A10T

There IS a working bootloader on the A10T. You have to press the "reset"-button while flashing! Crazy!
But now, I installed Klipper. The pins for E2 ARE right!

Here the working printer.cfg

I liked the idea of keeping the mass in the center of the X carriage, and looking at alot of other direct drive upgrades had the motor to one side or the other.

The ender 3 has a smaller X carriage than the A10 so I designed one in Fusion.

The small electronics board is mounted on top of the extruder motor.
Kroger Eschedule

The board of the index has a field about the article anywhere at any time no matter you are in pain or happy but the presence of God is compulsory at that place. The marriage encounters are the facing of iv therapy phoenix all the time and at any place.

We have recently come to know about the error 3835 while watching on Smores.TV and Engageme.TV and we have set out to fix hideouttv error 3835 using some basic troubleshooting techniques.