Page 1 of 1
MK8 feeder upgrade
Posted: Tue Nov 12, 2019 3:32 am
by choadicus
Hello,
We installed the Geeetech MK8 feeder upgrade on E1 and it is over extruding. The old original feeder on E0 still works fine. Is there something we need to adjust to fix this?
Re: MK8 feeder upgrade
Posted: Wed Nov 13, 2019 2:18 am
by choadicus
Thanks Vert. We have another MK8 on the way. What parameters do we need to change to make the feeders work correctly?
Re: MK8 feeder upgrade
Posted: Thu Nov 14, 2019 3:24 am
by choadicus
Hello again,
We changed the Esteps to 98 by turning the function knob and it prints perfectly BUT when we turn it off the Esetps go back to 430. How do we make it stay 98 permanently?
Thanks
Re: MK8 feeder upgrade
Posted: Thu Nov 14, 2019 3:45 am
by choadicus
Got it. Done. Thanks for all your help. Believe me we will be back in touch. Take Care.
Re: MK8 feeder upgrade
Posted: Thu Nov 21, 2019 3:50 am
by choadicus
Hello again,
Are all nozzles the same or should we only get Geeetech ones?
Thanks