Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://geeetech.net/forum/

Install a Chimera extruder on A10m

http://geeetech.net/forum/viewtopic.php?f=98&t=69495

Page 1 of 1

Install a Chimera extruder on A10m

Posted: Fri Nov 01, 2019 5:41 am
by martintaurer
Hi all out there - I would like to convert mu A10m to a Chimera extruder - I already have one here. The challenge is - how to get the electrical stuff working - two hotends..
Secondly - do I need to change the firmware?
Any tip welcome

Re: Install a Chimera extruder on A10m

Posted: Fri Nov 01, 2019 9:24 am
by William
Hi, If you want to replace the hot end, you may need to replace the corresponding motor and wiring.
Change to the firmware corresponding to it.
All times are UTC+08:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/