Geeetech

Posted: **Sun Oct 27, 2019 5:21 am**

Hi all,

Been printing successfully for a while now and suddenly receiving ERR: MINTEMP, PRINTER HALTED please reset. I’m not using any bed clips.

I’ve had a look and can see any soldier issues.

Any ideas,?

Posted: **Mon Oct 28, 2019 9:17 am**

Hi, you can check if your thermistor is fully connected.
If you are fully connected,
you can try to measure the thermistor with a multimeter.

Posted: **Tue Oct 29, 2019 5:32 am**

Thanks all, there was a break in the green wire. There is quite a bit of movement with the wires as the bed moves back and forth.

Geeetech

A10 Super Plate Min Temp ERR

A10 Super Plate Min Temp ERR

Re: A10 Super Plate Min Temp ERR

Re: A10 Super Plate Min Temp ERR