Geeetech

I have an A10M but am fed up with the terrible hotend and don't have time for the endless tweaking it seems to require. I've had this thing for almost a year and have barely printed anything because of how bad it is.

I'd be fine putting in a single extruder/nozzle hotend, just so I can get some decent prints. Any recommendations? Thank you.

Hi,Are you referring to changing the hot end of the two in and one out into the hot end of one in and one out?
You may need to replace the hot end, the extruder motor
Fix the part of the extruder motor.
Specifically, you can refer to the picture of A10 for replacement.