Page 1 of 1
Re: A10 filament feeder motor not feeding
Posted: Sat Oct 19, 2019 8:24 pm
by Fugly
When you leave the filament out of the extruder and just heat the hotend up (make sure you leave a peace of filament in the runout sensor) and then move axis extruder forward.does it then run normally?
Re: A10 filament feeder motor not feeding
Posted: Sat Oct 19, 2019 10:12 pm
by Jarda3d
Possible contact oxidation. Sea shipping is corrosive. Train shipping on Silky Road loose screws...
Re: A10 filament feeder motor not feeding
Posted: Mon Oct 21, 2019 9:29 am
by William
Hi, you can check if your extruder motor is working properly for a week.
If not, you can try to swap the motor wires of the other axes to the extruder motor line for viewing.
Determine if the motor line is broken and this happens.