Geeetech

Posted: **Sat Sep 21, 2019 6:48 pm**

I recently bought 3D touch to my A10M and tried to install it using preconfigured marlin 1.1.8 (can be found here https://www.youtube.com/watch?v=8o--HmfZ57I). 3D touch seems to be working (?) but everytime i try to start printing from SD the screen just goes blank and nothing happens. When I disconnect the 3D touch and upload configuration without 3D touch printing works fine again. Any ideas why this might happen?

Posted: **Mon Sep 23, 2019 9:21 am**

Hi, You can try using another SD for printing attempts.
Or press the card slot to try when inserting the SD card.
I hope this can help you.

Geeetech

Print not starting when 3d touch is connected (a10m)

Print not starting when 3d touch is connected (a10m)

Re: Print not starting when 3d touch is connected (a10m)