Geeetech

So I just got into 3d printing with my Geetech A10 and after solving an issue with a clog in the hotend I tried printing a few calibration cubes and the first layers are all turning out kinda gross like this. I am using solutech 3d pla and slick with cura, which I think I got all the right settings with. Is this an extrution issue. I am also worried about my filament balling and curling at the tip like this any ideas on what I need to change to remedy this. I don't think it's a clog since I just got one out and when I removed the nozzle I was able to see straight through the top of the extruder to the build plate, but who knows, thanks for any help.reverse phone lookupnba reddit pcpartpicker

Hi, Can you provide a specific picture?
So that we can solve the problem better.
If you are referring to printing the first layer of a mess,
You can try to re-level the hotbed.
Or if the hotbed temperature is too high, try to reduce it by 5-10°.
I hope this can help you.