Geeetech

I recently got a A10 as a gift and I'm trying to print some test pieces. Initially everything looks ok, however, after cca 6 mm are printed the printer stops with a MINTEMP error message. Any suggestions how to resolve this issue?

Hi, You can check if the thermistor wiring of your hot end and hotbed is fully connected.
If it is fully connected, it can be measured.
and you can refer to this: http://www.geeetech.com/forum/viewtopic ... 23&t=17030

I hope this can help you.

Hi, thanks for your answer. I tried to figure out what to do, but I'm not sure what I'm looking at
Could you be more specific which connectors I should be looking at (I attached the image of the board)?
Thanks!

Hi, You may need to check to see if the extruder's thermistor is fully connected.