Geeetech

Dear fellow A10M users,

I have an issue with my A10M : No filament going out of the hot end. It's not clogged because I have cleaned it and finally changed it by a new one with the exact same issue.

I also changed the PTFE by new ones and check the connectors too. Everything seems to be alright.https://sarkariresult.onl/ Mobdro https://pnrstatus.vip/


I suspect both extruders not pushing enough the filament. I have adjusted the screws and cleaned the gears. It was working with under extrusion for a while. Now it’s not working again. I have planned to install metallic ones instead of the original plastic one.

Some help would much appreciated
Thanks in advance

Hi, You can try
1. Manually heat the nozzle to 200° and then push the consumable to see if the nozzle is discharging;
2. Check the spring tension of the feeder;
3. Check if the extruder motor is running normally. If it is not working properly, you can exchange other shaft motor wires to the extruder motor for viewing;
4. Check to see if the Teflon tube is fully inserted.
I hope this can help you.