Page 1 of 1
A 10 wheels
Posted: Tue Jul 30, 2019 1:42 pm
by Adriano
Hello , i noticed one of the 3 wheels on the right side of the X carriage isn't touching the frame at all. I think there's 1 or 2mm gap . I never fixed any nut since i got the printer and printed parts are great but ..have one of 3 wheels loose isn't good me think. Any suggestion about how to fix please ?
A clarify picture on attachment.
- Ruota.jpg (146.77 KiB) Viewed 6667 times
Thanks in advance,
Adriano
Re: A 10 wheels
Posted: Tue Jul 30, 2019 1:48 pm
by William
Hi，You can try to tighten it with a tool.
Re: A 10 wheels
Posted: Tue Jul 30, 2019 7:32 pm
by Adriano
Hello,
the wheel is tight but distant from the frame...seems the end plate isn't straight but little "oblique" . I'll have to see if i can put it more close to the frame ...i see there's just one screw to do so but i'm asking if this the right way to do so
Re: A 10 wheels
Posted: Wed Jul 31, 2019 9:07 am
by William
Hi, You can check if the bearing wheel and the slide rail match,
if it does not match, you can replace it.
If there is a gap in the middle,
you can try to loosen the bearing wheel
and then screw it to the appropriate position and then tighten it.
Re: A 10 wheels
Posted: Thu May 14, 2020 5:15 pm
by InvisiKing
Did you ever managed to fix this issue, if so what did you do?
Re: A 10 wheels
Posted: Fri May 15, 2020 2:37 pm
by William
InvisiKing wrote: ↑Thu May 14, 2020 5:15 pm
Did you ever managed to fix this issue, if so what did you do?
Hi,what is your problem?please