Geeetech

Hey guys, after perusing the forum for a while I haven't found anything relating to getting boards like the MKS Gen L or SKR 1.3 installed on the A10. I believe I recently fried my GT2560 (apparently LEDs are not as harmless as I anticipated) and am looking to replace it. A replacement GT2560 costs almost $50, and I could get boards like the above mentioned for much cheaper than that, with the plus being that they're a bit more mod-friendly and in the case of the SKR take advantage of 32-bit architecture. I haven't decided which of these boards to go with and wanted to see if anyone has tried it and found one to be more compatible with the stock A10 wiring, etc.

TLDR; Anyone have recommendations for switching from GT2560 to another board?

Hi, The schematic of our motherboard is open source, you can view it:https://github.com/Geeetech3D/Prusa_I3_ ... evA%2B.pdf

do they exist a preconfigure version of Marlin for Ramps 1.4 for replacement of the problematic gt2650 v3 board its my second motherboard and another defective one im dissapointed a loT!

weldingboy73 wrote: ↑

Sat Aug 03, 2019 5:17 pm

do they exist a preconfigure version of Marlin for Ramps 1.4 for replacement of the problematic gt2650 v3 board its my second motherboard and another defective one im dissapointed a loT!

Hi, I am afraid there is no