firmware problem
Posted: Sat Jun 29, 2019 5:21 pm
Hello, i have a problem on my printer
Its a geeetech a10
I upgraded it with an e3d v6 and updated the firmware with the one for a10 from geeetech github.(marlin 1.1.8)
auto home from lcd works fine but home when printing(after heating) doesnt work, the printer crash into the z endstop and doesnt aknoledge it at all.
When auto home from lcd the microstepping before touching z endstop doesnt work.
Where can i find a firmware for geeetech a10 without bl touch that would work properly ?
thanks
Its a geeetech a10
I upgraded it with an e3d v6 and updated the firmware with the one for a10 from geeetech github.(marlin 1.1.8)
auto home from lcd works fine but home when printing(after heating) doesnt work, the printer crash into the z endstop and doesnt aknoledge it at all.
When auto home from lcd the microstepping before touching z endstop doesnt work.
Where can i find a firmware for geeetech a10 without bl touch that would work properly ?
thanks
