A10M Overheating problem

Post Reply
ToyaHSW
Posts: 1
Joined: Fri Jun 14, 2019 2:59 am

A10M Overheating problem

Post by ToyaHSW » Fri Jun 14, 2019 3:01 am

After the first print, I encountered this error.
I can't control the temperature and go up to 270-280 degrees.

What could be the problem?

Image
Top
User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: A10M Overheating problem

Post by William » Fri Jun 14, 2019 9:55 am

Hi, maybe you need to replace the thermistor on the motherboard and measure the resistance between the blue and green lines on the hotbed.
-Keep your mind and try to test it. :)
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Top
SKP
Posts: 1
Joined: Sun Jun 16, 2019 1:37 pm

Re: A10M Overheating problem

Post by SKP » Sun Jun 16, 2019 1:41 pm

i have the same problem with my a10! it just goes up and overheats! did you figure out why?
Top
Jarda3d
Posts: 189
Joined: Sat Jan 26, 2019 8:42 am

Re: A10M Overheating problem

Post by Jarda3d » Sat Jul 06, 2019 1:59 am

Try to use some contact spray.

At the first print I was problem with Z axis, where are bad contacts due oxydation
A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
Top
Post Reply

Return to “Geeetech A10 Series”