Geeetech

I just downloaded, compiled, and flashed the Marlin 2.0.X firmware. I followed the instructions on vert's thread and downloaded it from the Marlin 2.0 Bugfix Branch linked on the thread.

Vert's Thread - http://www.geeetech.com/forum/viewtopic ... 20&t=68228
Marlin 2.0 Bugfix Branch - https://github.com/MarlinFirmware/Marli ... gfix-2.0.x

Everything works great but I don't think the printer has BLTouch auto-leveling enabled. I used the example config included for the A10M and when I select auto-level in the printers menu the printer just goes through the manual bed leveling process. I am relatively new to Marlin and after looking through the config file, I can't seem to figure out how to enable it. Any help would be appreciated.

You can attach your configuration.h file and we can help to check it.

Hi Vert, or any one that can help

Could you please re-post the location of your Marlin 2.0 for the A10m with BL touch, as i ,have used all you links with no success, the Thingiverse, errors 404.

Thank you