Geeetech

Hey guys,

sorry to bother you, but i do have a problem to install the firmware for the 3d touch sensor.

I installed the sensor physically just to find out that i have to flash the firmware.
I downloaded the software here:

http://www.geeetech.com/forum/viewtopic ... 13&t=17181

then "open" marlin in arduino and uploaded that.

After that was done i restarted the machine and everything seemed fine. But i couldnt find the point in the menu to install the 3D touch sensor.
Then i realized that the printer is now not even recognized by my computer anymore...

Does anyone know what i can do now ?

Sincerely

Sack

Thank you for the file. Do you know where i can get the 1.8.5. version? i only have the 1.8.9 version of arduino IDE

Refer to it:
https://www.arduino.cc/en/Main/OldSoftw ... ases#1.0.x

Ok, so with the new files i was able to update the firmware again, it now has the menu buttons etc. and when i ask it to auto level it runs an auto level.

But if i now start it from cura with "print via usb" it does auto leveling and then at the end of it stops and doest start printing at all...

Hi,
Could you attach a video link?
I am a little confused.