A10M starts to print then stops and then unloads filament
Posted: Sat Apr 06, 2019 11:12 pm
Is there some sensor or setting that makes it do this it does it both when printing from SD card or with connected computer. i have update the firmware when i installed the Bltouch. it was printing fine did 10 prints started a big print and got to 45% done when it did this the first time. Worked another 15 minutes and did it again. Filament sensor are on and do work. it was running for 12 hours when i got to the 45%. it then somehow aborted the print so i could not finish it. and now it does the whole filament unload cycle almost immediately after starting a project then after you get it going again 5 minutes later does it again. Any help would help.