Bl Touch on a10m
Posted: Fri Mar 29, 2019 8:15 am
Well thanks to Vert, and banging my head against the wall, Finally got marlin to update.
But I am having problems with the BL, and honestly think I got a dud.....
Arduino gives me this when I try to home Z..
"Error:STOP called because of BLTouch error - restart with M999
Error:Printer stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting)
X:152.00 Y:115.00 Z:10.00 E:0.00 Count X:12160 Y:9200 Z:4000
now I did the m999 and it did nothing.
a) was I suppose to disconnect the endstop?
b) there are no leds working on the Bl, and doesn't respond to any commands thru the printer controls
But I am having problems with the BL, and honestly think I got a dud.....
Arduino gives me this when I try to home Z..
"Error:STOP called because of BLTouch error - restart with M999
Error:Printer stopped due to errors. Fix the error and use M999 to restart. (Temperature is reset. Set it after restarting)
X:152.00 Y:115.00 Z:10.00 E:0.00 Count X:12160 Y:9200 Z:4000
now I did the m999 and it did nothing.
a) was I suppose to disconnect the endstop?
b) there are no leds working on the Bl, and doesn't respond to any commands thru the printer controls