Geeetech

Hello,

I am quit new at 3D print.
I download Cura 4.0 but I can not install the Geeetch A10 according to http://www.geeetech.com/forum/viewtopic.php?t=61568
Where is my fault?

Many thanks in advance

best regards

Mathias

Hello,

you are right if you have a little experience.
In my case I will start do find wit 3D print. As beginner is it more helpful to start with working systems.
There are enough variables and settings which have to set.

Best regards

Mathias

I am having the same issue

hello,

can you explain how we can do that?

Thanks in advance

Mathias

You can also just add a Creality End-3 printer and then rename it as your A10. Then change the bed size to 220x220x260 and modify the start gcode in 4 locations from 0.1 and etc to 10.1 and etc (by just adding a 1 in front of the "0.1") to get the twin lines of filament purge to remain on the print bed vs. falling off towards the circuit board fan. All else should work just fine.

Hi,
If you want to set the print area.
I suggest you set it to "235X228x260"