Hi guys, sorry for my bad English, I try to explain better then I can!
I buy an a10 few days ago and I print the dog on the SD.
The print was good. Then I download some small models and try to print. bad, the object was full of microholes.
OK, I download the ultimate cura, I follow a video for setting and start but the Filament now don't paste on the base and it tangle around the extruder.
I try to print again the dog but got the same problem.
What I have to do?
Problem: the Filament don't paste to the base
Re: Problem: the Filament don't paste to the base
It seems you need to check the bed leveling at first.
Refer to this pic then adjust it again
Refer to this pic then adjust it again
- 通用调平示例.jpg (50.77 KiB) Viewed 1933 times
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!