Brand New A10M first print issue direct
Posted: Sat Jan 26, 2019 4:06 am
Tonight I was going to make the first print ...
I started ok of sample on SD card "Dog"
and get about layer 30 the temp for nozzle show 340 celsius
and it started get smoke from printer nozzle.
I stop the print ...
But the temp on nozzle not get lower, I turn off and restarted
but then the temp started to get high again.
As soon I connect it and power on the nozzle get super hot 320-340 degree celsius.
Almost started a fire
I get so angry since there was some other issue with extra add on like Auto Level that
I bought but not could have installed on printer due to strange behaviour like Z 0 point
change by +5 mm each time I sent command to go home.
It get home 5 mm tiger each time so I was needed to unmount this
Could this be short cut in mainboard ?
Sorry that I sound angry .. but I have issue to get auto level work, then the first print
it get broke after about 30-40 layer of sample dog.
And almost started a fire ... so that's is why I was so negativ
What to do ?
Kind regards / Ola