A10M Filament issue
Posted: Wed Dec 26, 2018 11:20 am
Hi,
I just got my A10M setup and working and I printed about 6mm of a Benchy before the filament started back feeding up the second bowden ptfe tube instead of going out the print nozzle. Any ideas or suggestions on what's causing this and how to fix it?
I just got my A10M setup and working and I printed about 6mm of a Benchy before the filament started back feeding up the second bowden ptfe tube instead of going out the print nozzle. Any ideas or suggestions on what's causing this and how to fix it?