Page 1 of 1
nozzle that clogs at 10m
Posted: Wed Dec 19, 2018 11:55 pm
by casimir24
hello my buzzard gets blocked and makes me a big dough.
Can you help me?
kind regards
Re: nozzle that clogs at 10m
Posted: Thu Dec 20, 2018 1:24 am
by _kaktus_
Hello.
This can happen when the PTFE tube is not pushed deep enough.
It must be cut off evenly, it cannot be cut off at a slant
Re: nozzle that clogs at 10m
Posted: Thu Dec 20, 2018 5:20 am
by casimir24
Thank you very much it works again
good evening
and hello from France.
Re: nozzle that clogs at 10m
Posted: Thu Dec 20, 2018 9:46 am
by William
_kaktus_ wrote: ↑Thu Dec 20, 2018 1:24 am
Hello.
This can happen when the PTFE tube is not pushed deep enough.
It must be cut off evenly, it cannot be cut off at a slant
Totally correct!
