Geeetech

Posted: **Mon Dec 17, 2018 9:12 pm**

Hi,
I just assembled a new A10 and did first print, works great!
There is a black plastic square part with a bearing inside it and rail-mount nuts on the bottom of it in the parts bag - I could not see that part in the documentation but I don't what it's for - can anyone tell me?
Thanks

Posted: **Tue Dec 18, 2018 3:38 am**

It is the z rod guide that goes on top of the lead screw

Posted: **Tue Dec 18, 2018 6:07 am**

vert wrote: ↑
Tue Dec 18, 2018 4:18 am

APLEES wrote: ↑
Tue Dec 18, 2018 3:38 am
It is the z rod guide that goes on top of the lead screw
was not thinking of this but yea sounds about right.

Defo not clearly stated in the build instructions.

Posted: **Fri Dec 21, 2018 10:32 pm**

Thanks for the help. Had the same problem

Posted: **Sun Dec 23, 2018 7:15 pm**

APLEES wrote: ↑
Tue Dec 18, 2018 3:38 am
It is the z rod guide that goes on top of the lead screw

That was it, thanks!

Geeetech

What is the part with bearing in for?

What is the part with bearing in for?

Re: What is the part with bearing in for?

Re: What is the part with bearing in for?

Re: What is the part with bearing in for?

Re: What is the part with bearing in for?