Page 1 of 1

A10M Mixing color

Posted: Fri Dec 14, 2018 12:42 am
by robbyrossi
Hello community,

I have bought a Geetech A10M but in "easy print" I not found a way to print with mixing color/dual extruding and not found A10M printer (also firmware upgrade).

There are a guide to print with mixing color with easy print and see A10M printer?

Please help me

Thanks in advance

Regards

Re: A10M Mixing color

Posted: Sat Dec 15, 2018 8:34 pm
by Akuma
Sorry I don't know what "easy print" is. I would try going on YouTube. There are plenty of videos showing how to dual colour print with it. That's how I learned

Re: A10M Mixing color

Posted: Sun Dec 16, 2018 12:01 am
by _kaktus_
Hello.
:mrgreen:

This is a software of the GT brand, functionally similar to Repetier-Host and the like. ;)

When you issue a T1 or T0 command while printing, the active extruder is switched.

In addition, check that your model has a function in the control panel that allows you to mix and / or switch the active extruder.

Adding commands I was talking about directly in the prepared Gcode script will switch extruder support. When you load two colors of filament into extruders, you will receive a two-color (or more) printout.
:D