Hello,
It is the first time I use my printer and when I press Auto Home, the Z axis goes up instead of going down...
When I move Z axis, the nozzle goes up but when I come back to 0 on the screen, nothing happens, the nozzle does not come back down...
It is as if the command to go down does not work...
Does someone have an idea to what I did wrong?
Thank you !
Sandrine
Auto home
Re: Auto home
1.Try to upload the firmware again
2.Check the A4988 broken or not(You can swap them)
2.Check the A4988 broken or not(You can swap them)
- Attachments
-
- GT2560V3.jpg (360.01 KiB) Viewed 3046 times
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!