Geeetech

Posted: **Wed Dec 12, 2018 4:51 am**

I unmounted the nozzle, to clean it.

Now it seems like it's leaking?

Any idea how to fix this?

Posted: **Wed Dec 12, 2018 6:03 am**

Hi,
you heat up before mount the nozzle ?

Posted: **Wed Dec 12, 2018 6:08 am**

Not sure.

Can I fix this?

Posted: **Wed Dec 12, 2018 6:16 am**

unscrew the nozzle in hot state, clean it and screw it back in hot extruder

Posted: **Wed Dec 12, 2018 3:45 pm**

Thanks.

How hot should it be?

Posted: **Wed Dec 12, 2018 5:11 pm**

Hello.

Heat it to the temperature you have set for printing.

Posted: **Thu Dec 13, 2018 2:53 pm**

1.Heating the nozzle to 220C
2.Clean the hotend
3.Re-tightness the nozzle and the throat

Posted: **Sun Dec 16, 2018 7:02 am**

William wrote: ↑
Thu Dec 13, 2018 2:53 pm
1.Heating the nozzle to 220C
2.Clean the hotend
3.Re-tightness the nozzle and the throat

Leaving the heat at 220 all the time even when mounting again?

Posted: **Sun Dec 16, 2018 3:09 pm**

Hi.

This is what it is all about to perform the assembly with hot components.

Posted: **Mon Dec 17, 2018 10:11 am**

If you want to remove the nozzle off,you need to heating it to 220C at first.

Extruder leaking?