Marlin 1.1.9 with & without bltouch + TMC2208
Posted: Sat Dec 08, 2018 6:58 am
I need help to make work my printer with the news drives TMC2208 for X,Y,Z,E0
Geeetech
Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://geeetech.net/forum/
Marlin 1.1.9 with & without bltouch + TMC2208
Page 1 of 1
Re: Marlin 1.1.9 with & without bltouch + TMC2208
Posted: Sun Dec 09, 2018 6:38 am
Yes, I have all mounted, but I wish optimizes the firmware of somebody need I can send it
Re: Marlin 1.1.9 with & without bltouch + TMC2208
Posted: Mon Dec 10, 2018 12:16 am
Re: Marlin 1.1.9 with & without bltouch + TMC2208
Posted: Tue Dec 11, 2018 5:33 am
the printer goes well and very quiet even, I had to adjust the Vref of the drivers and the steps of Extruder, now I think I lost some step on the Y axis.
Re: Marlin 1.1.9 with & without bltouch + TMC2208
Posted: Tue Dec 11, 2018 11:42 pm
But think that maybe the problem is cura because I print the same piece two time and all time I get the same defect
Re: Marlin 1.1.9 with & without bltouch + TMC2208
Posted: Thu Dec 13, 2018 1:14 am
I didn’t try
Re: Marlin 1.1.9 with & without bltouch + TMC2208
Posted: Thu Dec 13, 2018 10:18 am
You can try to use the slic3r then you can compare them :d