Geeetech

Hello guys, i get my first 3D Printer as a gift, but i cant get it to run.
My english is not very good, so i make lots of Pictures of my problem.
First of all, i get the A10 used with a scratched bed, but there a still clear places.

No matter what i do, the PLA dont stick.

Can anyone help me ?

Hello.


It is worth reading the latest topics related to this problem in subforum A30.

It's petg not pla.anyway you have to stay more high with the nozzle

You need to have your Bed up to a minimum of 65 ish to get anything to stick, look at the glass transition temperature of the material. start with that... Raise your hot end as you can see a shadow of where the extruder is slithering minute material on to the bed...

Also your hot bed looks way to shiny... should it not have a mat kind of finish...

Hello guys, thank you very much for your replies.
Yes, i was too inexperienced to work with 3d Printer.
After i realize that non every filament is automatically PLA, i change the temprature and got a
better result.

After that, i put some glue on the bed, and finaly, it worked. (But not good)

Here is a picture of my first successful print.



The quality is very poor, in this picture i have already do fine tune, but its still not good.
The bottom and the top layer looks bad and i have dont idea what i can do different.
I have a second print, but no picture. Its very unstable.
Sadly, i have to give up the printer, so i cant try something different.

Next time, i inform me better, but this get me lots of experience.
Have a great day

PS: Sorry for my poor english, i hope you got the point.