New A10

[Ken234]

Just setup my A10 did 1 print perfect,sliced another print and now it keeps triggering a filament change even on the print it did previously,I change nothing sliced in simplify and also it keeps saying paused to heat print head could there be something in the gcode that's wrong kinda confused at this point

[dekes1]

Just setup my A10 did 1 print perfect,sliced another print and now it keeps triggering a filament change even on the print it did previously,I change nothing sliced in simplify and also it keeps saying paused to heat print head could there be something in the gcode that's wrong kinda confused at this point

Not quite understanding your issue. Can you take a screenshot of the message?

[Ken234]

Every time I start a print it will do the 9 point for bed leveling then it does a wipe,as soon as it's done the wipe it stops and says waiting for filament change press button to continue.I reset the printer and unplugged the run out sensor and now it works again.So maybe it has something to do with the sensor

[William]

I have the same issue on my A10.
I replaced the extension board then it works.