Geeetech

Here you can share you great ideas about hardware innovation. Here you can enjoy more professional and specialized services, Here is a platform for you to make a difference!
http://geeetech.net/forum/

Share your A10 slic3r/astroprint settings ;-)

http://geeetech.net/forum/viewtopic.php?f=98&t=61949

Page 1 of 1

Share your A10 slic3r/astroprint settings ;-)

Posted: Wed Nov 28, 2018 10:18 pm
by WhippingBoy
Im using astroprint.

Does anyone have some good settings for astroprint?
Im quite sure they are using slic3r.

Also I always having a hard time removing the support material. any suggestions for settings here?

Re: Share your A10 slic3r/astroprint settings ;-)

Posted: Fri Nov 30, 2018 11:25 am
by William
You can refer to it:
A10-slic3r-config.zip
(1.7 KiB) Downloaded 1135 times

Re: Share your A10 slic3r/astroprint settings ;-)

Posted: Fri Nov 30, 2018 11:26 am
by William
Set the support to "Lines,5%"

Re: Share your A10 slic3r/astroprint settings ;-)

Posted: Mon Dec 03, 2018 10:32 pm
by WhippingBoy
Dear William.

I cant find support lines in the gui?
https://manual.slic3r.org/expert-mode/p ... t-material
All times are UTC+08:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/