Help A10M newly assembled
Posted: Sun Nov 25, 2018 11:33 am
Hi Guys,
I just finished assembling the new A10M (dual extruder, no auto leveling) that I have received today, and I was successful able to print the "dog" that was provided with the stock SD card.
After that, I don't know for which reason, I just turned the printer off and then on, the printer is not recognizing any gcode (including the dog that I was able to print before). In particular, with any gcode that I provide to the printer, stock gcode, or a gcode created by me, the printer is behaving very strange and is printing lines randomly even outside the hot bed, without any sense! In other cases is just holding a position, extruding infinite material.
I have also tried changing the sd card but with no luck.
I really don't know what to do, i suppose there is a problem with the motherboard, or with the firmware. What do you suggest me to do? I think that I could try to reflash the firmware, but I don't know if that could help, and I also don't know where I can find the stock firmware and how to flash it (via USB? Or I need some particular accessory?). I even don't know the reason why the printer suddenly started behaving in this way!
Please help. Thank you!
I just finished assembling the new A10M (dual extruder, no auto leveling) that I have received today, and I was successful able to print the "dog" that was provided with the stock SD card.
After that, I don't know for which reason, I just turned the printer off and then on, the printer is not recognizing any gcode (including the dog that I was able to print before). In particular, with any gcode that I provide to the printer, stock gcode, or a gcode created by me, the printer is behaving very strange and is printing lines randomly even outside the hot bed, without any sense! In other cases is just holding a position, extruding infinite material.
I have also tried changing the sd card but with no luck.
I really don't know what to do, i suppose there is a problem with the motherboard, or with the firmware. What do you suggest me to do? I think that I could try to reflash the firmware, but I don't know if that could help, and I also don't know where I can find the stock firmware and how to flash it (via USB? Or I need some particular accessory?). I even don't know the reason why the printer suddenly started behaving in this way!
Please help. Thank you!
