Geeetech

I've some trouble with my new A10 that i recived today, i've been trying to print for 9 hours without a single success, every time i try it's end up by fail.
I've updated firmware for 3d touch and i did bed levelling correctly (according to youtube video), im using quality 3d pla filement but no printed a thing yet!
Beside hardware issues that i've posted some photos i thought this printer was a good choice but now i'm not that sure!!!

https://www.youtube.com/watch?v=OXVknm-AEMg

Hello.


In the video you have prepared, you can see that the head is still too high.
That's why there is a problem with adhesion of the first layer of filament to the surface of the heat bed.

Thanks for reply,i've lowered the head as much as i can (A4 paper slides) but printing quality is the same, can't print a single thing.
Any suggestion?

https://www.youtube.com/watch?v=CK2C1_H0pK8

Hi.


Have you calibrated the extruder?
What kind of plastic do you use?

This forum contains information about your problems. Have you tried to work on your own?
It is worth reading this and that. It will be easier for you. You will become bolder.
Each of us once started and gained the necessary knowledge.
Whether your start will be easy and fast depends only on you.

Thanks kaktus, i've 3 different pla filement for the test i used the flement comes in geeetech package then i used others, for now i use this pla filement.

I have no idea how to calibrate the extruder and even don't know if it's calibrated.Im looking for solution on youtube and forums, so far i didn't go any further.

So you use PLA.
OK.

To calibrate the extruder, ...
I wanted to write an instruction for you but forgive me ....

It's easier for you to watch this video.

Thanks for the video, i've installed the pronterface and did the test, for 10cm asked i got only 2.5cm.
And also i've some problem like this, flement melt in extruder but didn't came out on 190°.Maybe i got the bad printer or some thing not right on extruder i don't know.

Which filament did you use for the test
The one from the Geeetech sample or the one you bought separately

The filament that i bought separately.
After a few test extuder end up like that.

This is normal when you don't solve a problem with the adhesion of the material to the heat bed.