Geeetech

when I bought my a10m I didn't realize that it would be so difficult,my mk2.5 was a breeze compared to this printer,if anyone can help get this sorted I would appreciate it.long story short I cant get the print to stick to the bed and ive tried resetting probe height with no success,it also does not do the auto level before printing.i flashed firmware from the forum for a10m with the 3d touch,but I'm ready to throw this thing threw a window

Have you added "G29" (Start auto level) command to your "Start G-code" section in the machine settings in your slicing software? This supposed to be the next line after "G28" (Home).

Any reason why my posts have been removed????

ebam2014 wrote: ↑

Sun Nov 11, 2018 1:25 am

Any reason why my posts have been removed????

You need to check if your post complies with the forum rules.

Ken234 wrote: ↑

Fri Oct 26, 2018 8:24 am

when I bought my a10m I didn't realize that it would be so difficult,my mk2.5 was a breeze compared to this printer,if anyone can help get this sorted I would appreciate it.long story short I cant get the print to stick to the bed and ive tried resetting probe height with no success,it also does not do the auto level before printing.i flashed firmware from the forum for a10m with the 3d touch,but I'm ready to throw this thing threw a window

How is your printer going on?
For a10m auto level:
https://www.youtube.com/watch?v=_RtsZDbR2po&t=59s

William wrote: ↑

Tue Nov 13, 2018 1:51 pm

ebam2014 wrote: ↑

Sun Nov 11, 2018 1:25 am

Any reason why my posts have been removed????

You need to check if your post complies with the forum rules.

Can't do this if I have had post deleted without explination!!!!!!!

I am having sort of the same issue. I got auto leveling to work fine. When I tried to print my filament would not stick to the bed. But if I tried to print from extruder 2 it stuck really well. Seeing only the color of the pla being different, I swapped my rolls of pla. I had white in extruder 1 and black in extruder 2, white was not sticking at all and black was sticking really well. So I put black in 1 and white in 2. I expected white to now stick, but black still stuck and white still would not stick. Only think I can think of is something with the white filament.

I found a work around for now, I print the first 2 layers in black then switch to white. The white wont stick to the bed but sticks great to the black layers

Maybe you can enable the baby step on your printer.
It will be more helpful.

William wrote: ↑

Wed Nov 14, 2018 9:15 am

Maybe you can enable the baby step on your printer.
It will be more helpful.

Baby Step!?????????????

Yeah baby step z , in the config.h file you use to compile the firmware