Leveling.
Posted: Wed Oct 24, 2018 11:49 pm
Step 1
Leveling (level corner --> next corner etc...)
Step 2
Print. First layer doesn't stick to the plate. Ok, tomorrow I will try again
Step 3 (day after)
Positioning the sheet and start levelling. Le extruder go down and the nozzle lock the sheet to the heat bed.
The day before the sheet was able to move between nozzle and bed.
Why?
Leveling (level corner --> next corner etc...)
Step 2
Print. First layer doesn't stick to the plate. Ok, tomorrow I will try again
Step 3 (day after)
Positioning the sheet and start levelling. Le extruder go down and the nozzle lock the sheet to the heat bed.
The day before the sheet was able to move between nozzle and bed. Why?