Page 1 of 1
Marlin firmware with BLTouch at ZMin
Posted: Sat Oct 06, 2018 11:50 pm
by Wolle82
Is there someone out there who can help with that?
Re: Marlin firmware with BLTouch at ZMin
Posted: Sun Oct 07, 2018 12:13 am
by bing91
Moin,
I post my configuration here. Please note that the wiring in the picture is wrong - you need to switch the yellow and blue wire. Together with my firmware it should work.
Hope it will help you.
Re: Marlin firmware with BLTouch at ZMin
Posted: Sun Oct 07, 2018 4:48 am
by Wolle82
Why do you post wrong pictures?
Re: Marlin firmware with BLTouch at ZMin
Posted: Sun Oct 07, 2018 7:53 am
by bing91
Because I made these pictures before I got it working. Just switch the zmin (yellow) and the signal (blue) wire in the connector and it should work.
Re: Marlin firmware with BLTouch at ZMin
Posted: Sun Oct 07, 2018 1:35 pm
by _kaktus_
Hi
Please include correct photographs. The current ones are misleading and may mislead users.
Many people rely on the photographs presented, paying less attention to the descriptions.
Wolle82,
Thank you for pointing out errors in presentations.
