Geeetech

I have a geeetech A10,

with the motherboard GT2560 REV B

Nothing appears on the display, I tried to reload the firmware 1.0.4 with arduino ide, but the .ino never finishes loading.
Coem can I solve? do I have to reload the bootloader? how can I do? I do not know where the pins are on my card, to load it.

THANK YOU!

Wich firmware you are using? The firmware with boot loader included? Please don't use this one!!!

Use the firmware without the boot loader.
With Arduino you need to use the correct version of the arduino -ide to flash the printer.

Onto GitHub you can found the newest version of the firmware:
https://github.com/Geeetech3D/Prusa_I3_3Dprinter A10_Marlin_1.1.8! for the A10!

Try them please.

fruffo wrote: ↑

Sat Sep 08, 2018 8:17 pm

I have a geeetech A10,

with the motherboard GT2560 REV B

Nothing appears on the display, I tried to reload the firmware 1.0.4 with arduino ide, but the .ino never finishes loading.
Coem can I solve? do I have to reload the bootloader? how can I do? I do not know where the pins are on my card, to load it.

THANK YOU!

Same things happen to me.
I write a guide: https://zonalimitatore.blogspot.com/201 ... rev-b.html
Tell me,when finish,if your sd reader work or not

I have the same issue on a brand new printer. Do you have the instructions in English? Looks like a great guide.

Thanks

take the guarantee right over geeetech support

mine printer had some failures from start (first meachanical trouble and bad parts and at last of sensor/ software board problem), and if i could jump into past i would never take a geeetech again

Hello,
I have an Anet A10 with 3d touch, with Gt2560 Rev B card.
Does anyone have a working firmware for the 3dTouch / BlTouch?
any version of Marlin is fine, as long as it works!
I can't find one
Thank you so much!