MichaelK wrote: ↑Mon Aug 27, 2018 11:12 pm
First: _kaktus_ said: Heatbed leveling!!!
Second: Print the calibration cube you see as attachment. (Unzip file and save them onto the SD-Card, put them into the A10 and print)
don't change any internals into the gcode file please.
The 20x20x20mm cube made for A10 with a A10 profile into Cura. My own profile.
It is possible that your printer didn't print the cube into the middle of the bed! This ist okay.
Print them after correct leveling your heatbed and post the pictures from the cube please.
Hi everyone!
I got some printing issues too.
The main problem is the random outlining if the y-axis.
There are nearly everytime i got a print over 2 hours the last layers out of line.
Atm its instand layershifting.
Allready solved the problem of underextrusion. At first i measured the amount of extrusion, while give the command to extrude 100mm. There the printer only extruded 90mm. After align the steps/mm for the extruder steper, there was no change in quality. I recognized the teflontube in the hotend wasnt fitted to the end. After deassembling, cleaning and refitting the tube. The results where way better.
Now is the problem with y-axis and not sticking together of inner and outer wall layers. There is allways a tiny gap between them.
I printed the cube from michaelk aswell and like u can see in the pictures, the letters x and y arent in the center. Dont know if this is supposed to be.
Would be very great to get some advices.
The picture below the testcubes is a print of the "AIO ALL IN ONE Test"
https://www.thingiverse.com/thing:2656594
There you can perfectly see the y axis problem i got atm.
) now when i attempt to print the 1st layers seem to be all over the place , doesn't stick to the heat bed , and from looking at the nozzle , the filament doesn't seem to flow as well as it did with the first print i've done. 
